Qlik Community

Qlik Sense Deployment & Management

Discussion board where members learn more about Qlik Sense Installation, Deployment and Management.

igorfernbi
Contributor

Multiple task in trigger event on qmc

Hello

I have a task that i want to run when one of my task get status failed. This task sends me a SMS message

I created one trigger event and added all the task that I want to monitor.

The problem is that is and AND port and not a OR port:

http://help.qlik.com/en-US/sense/September2017/Subsystems/ManagementConsole/Content/create-reload-ta...

"Repeat the steps above for all the tasks that you want to include in the trigger. A task can only be added once and is not displayed in the task selection dialog if it has already been added to the trigger. There is a logical AND between the tasks."

Thus, my task will only run when all tasks get failed status (almost impossible). Otherwise, I should create one monitor task to each task.

Does anyone know a work around to this?

Thanks in advance

1 Solution

Accepted Solutions
martinsandin
New Contributor III

Re: Multiple task in trigger event on qmc

Hello Igor!

You can create several task event triggers for a single monitor task to get a logical OR between the triggering tasks.

Hope that solves your problem!

2 Replies
martinsandin
New Contributor III

Re: Multiple task in trigger event on qmc

Hello Igor!

You can create several task event triggers for a single monitor task to get a logical OR between the triggering tasks.

Hope that solves your problem!

igorfernbi
Contributor

Re: Multiple task in trigger event on qmc

now you said it semms oubvius!!!

lifesaver!

thank you

Community Browser