Qlik Community

Qlik Sense Deployment & Management

Discussion board where members learn more about Qlik Sense Installation, Deployment and Management.

benjamin_abacus
New Contributor III

Qlik Sense installation with ports 443 or 80 in use

Hi,

we 're going to use Qlik Sense in a combination with our software solution. In cause, that we use a webserver with ports 443 & 80 too, we 're forced to shutdown our system before qlik sense installation.

Is there no workarround to setup qlik sense with pre-defined ports? e.g. after installation a short stop of the proxy service an a small change in a file?

THX for all good ideas or developing.

Benjamin

1 Solution

Accepted Solutions
herbert88
Contributor II

Re: Qlik Sense installation with ports 443 or 80 in use

Hi Benjamin

Unfortunatly there is no way to change this before the instalation, but you can change it manualy.

You have to access the Postgre database and change this configuration before starting Qlik Sense Services(just the Database service must be running)

Just take a look at Michael Tarallo comment in this topic Qlik Sense - Proxy Port - Can this be change

Regards

3 Replies
benjamin_abacus
New Contributor III

Re: Qlik Sense installation with ports 443 or 80 in use

Any Idea's???

herbert88
Contributor II

Re: Qlik Sense installation with ports 443 or 80 in use

Hi Benjamin

Unfortunatly there is no way to change this before the instalation, but you can change it manualy.

You have to access the Postgre database and change this configuration before starting Qlik Sense Services(just the Database service must be running)

Just take a look at Michael Tarallo comment in this topic Qlik Sense - Proxy Port - Can this be change

Regards

benjamin_abacus
New Contributor III

Re: Qlik Sense installation with ports 443 or 80 in use

Thx

Community Browser