New Models not showing on Access Point

[mgdotcom]

Hi All,

I hope someone could help me with this.

I'm using QV Server version 12.0.20200.0 without publisher. As of quite recently whenever I publish a new model, users are unable to access or see the model. When I login on the server and access, access point via local host I can see the recently published models. There is no section access. I have Doc cals and user cals. I have tried assigning doc cal because user cals cannot see or access the models.

In QV Management under system -> Qlikview servers -> Server -> Folders .The correct route folder is assigned

In QV Management under Documents -> Server .I can see the document.

There is no section access. I have also tried restarting services. Deleting models, meta data and shared files. I have tried restarting the server.It seems like everything is correct, I'm not sure what else I can do.

[marcus_sommer]

Do the users have access-rights to the folder(s) within the windows active directory where you keep the qvw's?

- Marcus

[mgdotcom]

Hi Marcus,

They can see all other models. They just cannot see the new ones.

[avkeep01]

Hi Mervin,

Maybe the "inheritance" isn't checked. So when you place a new .qvw in the accesspoint folder the rights aren't inherented from that accesspoint folder.

[marcus_sommer]

Now I remember a similar case here in the community where the reason was a delaying from the publisher (distributing them or setting the access-rights) which is customizable anywhere in the config-file. Unfortunately I don't remember enough to find this posting.

- Marcus

[mgdotcom]

Hi A.M.

Where would I change this?

[mgdotcom]

Thanks for trying though Marcus

[avkeep01]

Right here.

[avkeep01]

So don't disable it, just check whether it is disabled. If disabled then enable so the rights are copied from the folder.

[mgdotcom]

It ended off being an issue with access rights but on the models themselves. Went to properties, security and added users to the model.