Qlik Community

Ask a Question

QlikView Administration

Discussion Board for collaboration on QlikView Management.

Announcements
Become an analytics expert with Qlik's new 15 week course: Applied Data Analytics using Qlik Sense. READ MORE
cancel
Showing results for 
Search instead for 
Did you mean: 
Not applicable

Select one value works on developer tool but not on server

I am using the same list box on separate sheets. On one sheet, I want to allow all selections, so I use an alternate state such as all_values. On another sheet, I want to limit the selection on the same list box to one selection, so I check "only select one value" and use alternate state one_value. This works well in the developer tool. But when I put it on the server, it allows to select more than one value on both list boxes. Why would it act differently on the server?

Labels (1)
1 Solution

Accepted Solutions
ashfaq_haseeb

Hi,

What version Of Qlik You use?

I tried with 11.2 sr6 and it worked fine.

I believe you need to look at QlikView upgrade.

Regards

ASHFAQ

Regards

ASHFAQ

View solution in original post

5 Replies
xufei123
Partner
Partner

Try setting a trigger in the document setting. When opening this application, one default value in that field with "one_value" alternate state will be selected.

Fei

parthiband
Partner
Partner

Hi Mike,

Think, these 2 posts will you understand the problem and will make u arrive to the solution.

QlikView Maven: Always One Selected Value Really

Read also the comments..

Re: Always one selected value on Access point

Thanks

ashfaq_haseeb

Hi,

What version Of Qlik You use?

I tried with 11.2 sr6 and it worked fine.

I believe you need to look at QlikView upgrade.

Regards

ASHFAQ

Regards

ASHFAQ

View solution in original post

bellamae
Specialist
Specialist

Hi Mike

I have struck this with radio buttons, for some reason if no selection is made when you save it to the server it wipes the "only select one value" gets wiped so you need to reset it in the server copy but be aware to set it you will have to have a single option chosen.

Bella

Not applicable
Author

The problem went away when I upgraded to 11.2.  I also found that when I placed a new copy of the .qvw file on the server, that I needed to completely close Internet Explorer/Access Point and re-open it before I would see the problem go away.