Alternate States and Always One Selected Value

[#1]

Hi
I have been requested to use Alternate States in one of my sheets.
As this works fine the option for "Always One Selected Value" gets disabled in the alternate set.

I set a single value in the trigger of selecting the sheet but the user can still go in and change that or clear the selections.

Any hint how to circumvent?

[#2]

Did you find a solution to this?

Thanks

Fredrik

[#3]

Hi

It is not a limit of Alternate States, I can't remember the exact conditions that did not show me the checkbox enabled. Could have been a Formula as source for the Listbox.

Mit freundlichem Gruss

Jürg Maier

Datenbankspezialist

Wincasa AG

Immobilien-Dienstleistungen

Grüzefeldstrasse 41

CH-8401 Winterthur

Phone +41 52 268 87 68, Fax +41 52 268 89 30

juerg.maier@wincasa.ch<mailto:juerg.maier@wincasa.ch>

www.wincasa.ch<http://www.wincasa.ch>

Die Wincasa AG pflegt eine internationale Partnerschaft mit der Knight Frank LLP: www.knightfrank.com<http://www.knightfrank.com>

Von: fredrik.tham

Gesendet: Donnerstag, 8. November 2012 11:09

An: Maier Jürg

Betreff: - Re: Alternate States and Always One Selected Value

QlikCommunity<http://community.qlik.com/index.jspa>

Re: Alternate States and Always One Selected Value

created by fredrik.tham<http://community.qlik.com/people/fredrik.tham> in Development (QlikView Desktop) - View the full discussion<http://community.qlik.com/message/278915#278915>

[#4]

Hmm... it was right in front of me . Below the trigger settings there is a box where you set which state it should affect.

// Fredrik