Flat Gauges

[vanderson009]

Hi Community,

Could any one please explain how this chart would be working.

-- Regards,

Villyee

[Anonymous]

Hi,

It's just an idea, an example as how to use the design tools to adjust tha gauge object for a flat and friendly design.

Marc.

[awhitfield]

As Mac says, they are just design example only! There's no 'real code' behind them

[mvanlutterveld]

If you take a look in the properties (presentation tab) of the gauge in the upper left corner of this app, you’ll notice three key parameters:

• - Fill to Value
• - Cylinder Thickness = 0
• - Angle span = 180

The Fill to Value parameter shows the red segment filled until it meets its value (65% as stated in the Expression box). By setting the Cylinder Thickness to 0 you get a circle like representation of the gauge. The Angle Span = 180 creates half a circle (180 degrees) that represents 100%.

This gauge is a two layered gauge. One for the red part (65%) and one for the grey part (65 – 100%).

[Viktor]

1. How to place " ABC " above the strip? 2. How to add a dotted line at the bottom