Skip to main content

QlikView App Dev

Discussion Board for collaboration related to QlikView App Development.

Announcements
QlikWorld 2023, a live, in-person thrill ride. April 17 - 20, 2023, in Las Vegas! REGISTER TODAY
cancel
Showing results for 
Search instead for 
Did you mean: 
vanderson009
Creator III
Creator III

Flat Gauges

Hi Community,

Could any one please explain how this chart would be working.

-- Regards,

Villyee

4 Replies
marcarreras
Specialist
Specialist

Hi,

It's just an idea, an example as how to use the design tools to adjust tha gauge object for a flat and friendly design.

Marc.

awhitfield
Partner - Champion
Partner - Champion

As Mac says, they are just design example only! There's no 'real code' behind them

mvanlutterveld
Partner - Creator II
Partner - Creator II

If you take a look in the properties (presentation tab) of the gauge in the upper left corner of this app, you’ll notice three key parameters:

  • - Fill to Value
  • - Cylinder Thickness = 0
  • - Angle span = 180

The Fill to Value parameter shows the red segment filled until it meets its value (65% as stated in the Expression box). By setting the Cylinder Thickness to 0 you get a circle like representation of the gauge. The Angle Span = 180 creates half a circle (180 degrees) that represents 100%.

This gauge is a two layered gauge. One for the red part (65%) and one for the grey part (65 – 100%).

Viktor
Contributor II
Contributor II

1. How to place " ABC " above the strip? 2. How to add a dotted line at the bottom

Снимок.JPG