NPrinting Connection

[Karl_Hart]

Hi all.

I'm just trying to set myself up on NPrinting and yesterday when I tested it everything was fine. However today, when I have set everything up I am having one issue.

On the Reporting Task section, I have set everything up but the Connection box is greyed out and it wont let me select one, even though I have set a connection up.

Does anyone know what I'm doing wrong?

[#2]

Hello Karl,

If you have already created a report then no need to set up a connection in the task. What you should be doing is Click on Reports next to General button and add the reports from there. You can also create a new report if not already created and specify the connection there.

Cheers,

Amit Prabhudesai

[christian77]

Hi.

To create connections qlik on Sources. Then create it.

On you report you don't create but use connections.

If you only have a connection, the logical thing is that your report is using that one.

NPrinting has a little hard interface.

I wish you all very good luck, and to myself too.

Still I think is better than doing the macro myself after a rich meal, like beans & rice & more beans & more rice, everything together with sour cream and more sour cream.

Leave the beer for tomorrow when you have finish your job.

[Karl_Hart]

Cheers for the help guys, I think I know what I should be doing but my issue is that the box where you select the connection is grey-ed out.

I've even tried to create a new template and I cant select anything from there either.

I've tried setting up a new connection but it seems like none of them are being picked up

[christian77]

Hi.

I have a connection. It's set up a default connection. Now I go to reports. I see a report on the list. I select it. In the lower box I read: Connection: My Document.

Now, I go to reports. I create a new one. Then I qlik on new template. I clik everything. I save as, I save it, I save and close it, even I pray.

Then I go to the list. I see my new report. I see on the lower properties box, Connection: I see nothing. Absolutely nothing is what I see. Oh my god! Where is the connection. You are right. It is broken or I don't know how to use it.

You are right, go up to Vizubi and let them know.  Knowledge Base – Customer Feedback for Vizubi

Well, I have to leave you, I almost finished my first 15 sheets report.

Good luck.

[christian77]

And, If I don't know, then, how I came to this point, cause my report is connected and I did it myself.

[#7 · Accepted solution]

I know the  interface is bit confusing and hard to understand. Hope this doc helps.

[christian77]

Okay, thanks.

I have this one. Unfortunatelly is in only in Spanish.

Also there is the NPrinting site with on-line and downloadable tutorials.

The thing is that sometimes I follow a chapter line by line and It still does not work.

[miikkaqlick]

Hi!

Check your Sources sheet.

Last button on left side.

Br,

Miikka

Climber Finland

[Karl_Hart]

Good man. The connection is created when you go into the template and right click to add an object.

Thank you very much!