Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
How do can I make a table to fit the width of the page if the page is a multi-page? The "fill" and "fill with aspect" option don't seem to work like when it is not a mult-page. Any ideas?
Thanks, Karl
I've had a similar problem and had to use a work-around as setting the print settings to 1 x 2 pages.
It seems as if your object is narrow enough, multi page is fine. But if your object is (too) wide, you can't use 'clip' and fill/ fill with aspect fill only the current sheet.
I've had a similar problem and had to use a work-around as setting the print settings to 1 x 2 pages.
It seems as if your object is narrow enough, multi page is fine. But if your object is (too) wide, you can't use 'clip' and fill/ fill with aspect fill only the current sheet.
That will have to work for now. Thanks, Matt.
hi,
I had the same problem with my object on the report. and this solution worked fine for the big charts. but my chart can always have a diffenrent width. and when the chart is a little bit smaller it stretches it out on the whole page and I dont want that. I have tried a kinds of settings but I didnt find a solution. either the small chart is streched out or the big chart need ceverall pages because of the width.
does anyone know a solution for this problem?
regards,
MT
Hello,
You could try with the option "Scale To X %" in the same place.
Regards,
Ginés.
Hello,
The two ways I have found for this are the options:
Scale to X % (you have to select the scale carefully.
The option as you have said fit to pages (but if you document fill more than 2 pages do not work either, the limit you can put in this option is 1 x 2000 and it works for any number of pages between 1 and 2000.
I have chosen the second one with that limit.
Regards.
Ginés.