There was a problem sending the command to the program!!!

[#1]

Hello everyone,

I had a problem when startup QlikView in the form of message box like on the picture below.

This message showup only when I start the program, but I could use QlikView normally. I use QV 11 SP1.

Then I uninstall QV 11 SP1 and install QV 11 and everything works ok.

My question is:

Whether to leave this version of softwer (QV 11)?

Which are the differences in QV 11 and QV11 SP1?

Thanks to all

[Anonymous]

Hi,

I've got the same problem and still can't find a solution... My QV doc is really low now, after the appearance of the error!

Has anybody an idea about that?

Thanks to you all

Bye

IB

[#3]

This was a Bug in the 11.00 Version and fixed with later Version (11.00 SR2 and never)

Would update to Version 11.20 SR7

[Anonymous]

Hi,

what about if I'm using 11.20 sr05?

thanks

IB

[#5]

If you see this in 11.20 SR5 I would recommend to open a support Case to see what is causing this issue again, but better first test if you see it also in SR7

[Anonymous]

Hi

It seeems it's all working right with SR07!!!

Thank u Daniel!!!

IB

[#7]

Hello ,

We are also facing the same issue. We are using QV 11 SR 13. Can you please provide us a possible solution to overcome this problem.

Thank you in advance.