Skip to main content
Announcements
NEW: Seamless Public Data Sharing with Qlik's New Anonymous Access Capability: TELL ME MORE!
cancel
Showing results for 
Search instead for 
Did you mean: 
paul_hallwood
Contributor II
Contributor II

Variable with multiple values used in Set Analysis

Hello all,

I was wondering if someone can point me in the right direction.  Basically I have a variable varGeographicalArea that is defined as follows:

varGeographicalArea = =if(Left(GetFieldSelections([Geographical Area]),3) = 'NOT','NOT',replace(Concat(DISTINCT chr(39)&GetFieldSelections([Geographical Area])&chr(39),','),',',chr(39)&', '&chr(39)))


So this variable can have multiple values contained in it.  e.g. 'Place_A', 'Place_B', 'Place C'


Now, when I stick this variable in a formula for a textbox, it only seems to give me the total value for the first value held within the variable varGeographicalArea.  This is despite the variable varGeographicalArea holding the value 'Place_A', 'Place_B', 'Place_C'.  Here is the formula I'm using for the textbox:


=Sum({1<[Geographical Area] = {$(varGeographicalArea)}>} [Incident_Count])


So, rather than expecting the total for geographical areas 'Place_A', 'Place_B', and 'Place_C', I am only getting a total for geographical Area 'Place_A'.


Any help much appreciated.



1 Solution

Accepted Solutions
marcus_sommer

A variable could contain only one single value at the same time and therefore you couldn't use them within the set analysis on a row-level. But I think in your case the following should be working:

=Sum({1<[Geographical Area] = p([Geographical Area])>} [Incident_Count])

- Marcus

View solution in original post

6 Replies
sunny_talwar

Try this as your variable

varGeographicalArea = =Chr(39) & GetFieldSelections([Geographical Area], Chr(39) & ',' & Chr(39), 10000) & Chr(39)

marcus_sommer

A variable could contain only one single value at the same time and therefore you couldn't use them within the set analysis on a row-level. But I think in your case the following should be working:

=Sum({1<[Geographical Area] = p([Geographical Area])>} [Incident_Count])

- Marcus

paul_hallwood
Contributor II
Contributor II
Author

I think that's sorted the issue out very nicely!  Thank you very much for the speedy response.

paul_hallwood
Contributor II
Contributor II
Author

Hello Marcus - funnily enough your answer was spot on too!  Can we mark multiple posts as being the correct answer???

Thank you very much for getting back to me too.

sunny_talwar

I think marcus_sommer‌'s response deserve the correct answer here

paul_hallwood
Contributor II
Contributor II
Author

Done.  Thank you for your honesty.