Discussion Board for collaboration related to QlikView App Development.
Not sure if this title surfices what i am trying to achieve.
ive been asked to replicate a spreadsheet so it can be live in Qlikview, which can show trajectories on reducing a waitlist and improving performance.
I have set up variables on a snapshot date -Mar19 which show targets, actual, and wl reduction required etc.
i have then tried to use this in a chart to show by month so current shapshot minus Wl reduction required (which is based on Mar-19 snapshot) but it only puts the calulcation in the month of mar19, not every month after - is that becuase im referencing March in the variable?
is there a way of getting around this?
Can you share your expression, your variable declaration, maybe an app with some sample data?
i dont tihnk i can it has a lot of patient info in, and a lot of data wouldnt know where or how to chop it down.
pre built app i have taken on.
my variable for pulling total WL size
sum( if(MetricID='RE01' and ScoreCardDate='31/03/2019', Denominator))
my variable for pulling just the breaches
sum( if(MetricID='RE08' and ScoreCardDate='31/03/2019', Denominator))
which gives the performance
i have then calculated a target based on the actual which is 85% predominently (Traj_WLreductionTarget) to then create a Wl reduction figure
then in a chart i want to create a table that shows for each specialty the number of breaches each month actually, against the target each month which is
but becuase i have based all my variables on 1 snapshot (which i have to) , the target each month only works for that snapshot - it wont plot by month, i just need to take the wl reduction figure from the number of breaches each month
hope i have made sense. thanks for looking
i think i could easily quit on this, certain things you can do in excel better maybe.
I used to think Excel was better for certain things.
Please provide a table of sample data so we may serve you better. Change names, etc, if necessary, but I'm not getting a full picture from your descriptions.
Not sure if i understand you correctly , you are hardcoding for one month in your variable and want to calculate for each month . Removing the month filter and putting the calculation under a month dimension will make it calculate for each month . Its better you attach some sample file with test data explaining your scenario
ahh thanks - I see I have hard coded a actual snapshot date 31/03/2019 so if I try a month dimension it might work.
thanks! I will try this however I have been taken off this for a time for something more pressing 😞 never get time to develop.
thanks, don't be sorry - appreciate you looking and what I am doing it quite complex.
I need to work on something else now, so I will get back to this as soon as I can ( typical no development time when I get something juicy)
I will try reduce the app and scramble data and explain better what I am doing