register ssl certificate on qlikview webserver

[Masi_Sahargahi]

Hi,

Recently we are forced to change all websites from http to https.

I registered ssl sertificate based on the following instruction:

https://community.qlik.com/t5/QlikView-Documents/Enable-SSL-QlikView-Webserver/ta-p/1495958

 I did all the steps and   as a  last step I run the below command in cmd and I got this message:

The ssl certificate successfully registered,

 netsh http add sslcert ipport=0.0.0.0:443 certhash=0000000000003ed9cd0c315bbb6dc1c08da5e6 appid={00112233-4455-6677-8899-AABBCCDDEEFF}

I changed the port from 80 to 443 and sleceted  "use https"( in qlikview web server), then I reseted qlikview web server.

But nothing happened after that and access point didn’t load with new configuration.

Any help would be highly appreciated.

[BrunPierre]

Could you kindly share how you went about the steps?

[Bill_Britt]

Take a look at this. If you already have a Certificate look at the last couple of pages.

Bill

[BrunPierre]

I skipped the configuration on the IIS to use SSL, which is important for getting SSL to work with QV Webserver.