Chart showing thousand Symbol but expression not getting values divided

[ashishtams]

Hi All,

I have a bar chart with dimension as Date and the expression as SUM(PASS).

In the Numbers tab i have given symbol of

Thousand as K

Million as M

and Billion as B

The chart shows K symbol and the value as 7300 which is actually seven thousand three hundred, so the chart should show 7.3 on the bar of the chart else it should not show the K symbol. either one will be correct.

Not sure if i am missing anything here. 

Regards              

[marcus_sommer]

Unfortunately is this not implemented in that way - it showed only these symbol to the number within the chart. If you want to show your numbers as k or m you need the following:

num(YourExpression / 1000, '#.##0 k') // thousands

num(YourExpression / 1000000, '#.##0,0 m') // millions

You could this make dynamic with variables like:

vDivider:

1000

vUnit:

= pick(match($(vDivider), 1000, 1000000), '#.##0 k', '#.##0,0 m')

and as expression:

num(YourExpression / $(vDivider), '$(vUnit)')

- Marcus

[luciancotea]

It used to work like that, they screwed it with version 9 or 10 (can't remember). It worked in 8.5.

I raised the issue several times, once I even got a promise that will be fixed.... never happened.

[awhitfield]

Looks to be working in V12, unless I'm missing something

Andy

[swuehl]

Seems to work even in a recent 11.20 version (tested 11.20 SR11 X64).

Which version are you using? Could you post a screen shot?

Or are you talking about the value shown in the mouse over, which I think will just show the result in the format of the of the expression (not taking the symbols into account).

[luciancotea]

[nagireddy_qv]

Hi Ashish,

Please make sure to do the division in the expression itself. I have faced a similar issue with showing Millions and had to divide by 1000000 in the expression which resolved the issue.

[marcus_sommer]

You are right - in SR13 it worked in normal charts but not in table-charts because these options are grayed out.

- Marcus

[rwunderlich]

The scaling of the "Values on Datapoints" was restored about SR11, and it works in QV12 as well.

The popup value does not scale though.

See

Bar Chart Viz Tidbits in Version 12 | Qlikview Cookbook

-Rob