Missing tabs in QlikView reports

[qlikconsultant]

Hi,

I have a report with 3 tabs.

1.  I load the report without data I see this 3 tabs. 
2. Then I reload the report and I still see tabs.
3. I save the report.
4. I close the report.
5. Then I open the report and the tabs are missing.

Ctrl + Shift + S does not help.

The report is not initial created from me, I have only to change a few things.

All three tabs have Show Sheet set to "Always"

It seems it only that tab show what was selected when the report was saved.

Any ideas what could cause this problem?

[marcus_sommer · Accepted solution]

It sounds a bit like that the visibility of the tabs is controlled by a section access ... Just take a look within the script if there is any section access and/or within document properties in tab open if the use of section access is enabled.

- Marcus

[edwin]

this is a very curios case, @qlikconsultant can you share the qvw without data?

[qlikconsultant]

@marcus_sommer  Thanks, I think you are right there is section access. It seems another mess in that report.

@edwin  Sorry thats not possible. Also this report is mess and complicated. Believe me, you don't want to waste your time with that. 😀