Qlik Community

QlikView App Development

Discussion Board for collaboration related to QlikView App Development.

Announcements
Make your voice heard! Participate in the 2020 Wisdom of Crowds® Survey. BEGIN SURVEY
pandiarajan
Contributor

Section Access Issue

Dear All,

i have applied section access based on Branch code , in my section access file i have mentioned userid and relevant branch code then admin i have used * symbol . as per the requirement we didt allocate few of the Branch code in Section access file .

Now problem is admin can able to see only allocated branch code in section action access . do i need allocate all branch codes are in section access file or * symbol is enough

Thanks & regards,

Pandiarajan.R

1 Solution

Accepted Solutions
Highlighted

Re: Section Access Issue

If all possible values for Branch are not already present in the section access table, you must list them individually for one ADMIN user.

After the section access field Branch has all possible values listed (not the one in the data model), then you can use "*".

In section access, "*" does not mean all values in the data model, but all values in the section access table.

View solution in original post

4 Replies
Highlighted

Re: Section Access Issue

If all possible values for Branch are not already present in the section access table, you must list them individually for one ADMIN user.

After the section access field Branch has all possible values listed (not the one in the data model), then you can use "*".

In section access, "*" does not mean all values in the data model, but all values in the section access table.

View solution in original post

Highlighted
pandiarajan
Contributor

Re: Section Access Issue

thank you for your quick response  i will try ur suggestion

Highlighted

Re: Section Access Issue

You can take a look at this example for the same issue:

https://community.qlik.com/thread/291933#1438107

Highlighted
pandiarajan
Contributor

Re: Section Access Issue

Thank you very much . my problem solved now