Skip to main content

Qlik

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Not applicable
‎2015-07-06 12:24 PM

[SAP Report Connector] Mismatch detected. The Report file may be corrupt.

Hi Community Members !

I have an issue with SAP Report Connector.

When I run the reload I have the following message : "Mismatch detected. The Report file may be corrupt."

I dont have the problem on SAP QUAL and DEV environment but only on PROD environment.

sapreport.png

The same discussion was already opened last year, but it has been closed : Sap Report Connector Page Cut.

Does anyone have an idea to solve this ?

Thanks a lot for your help !

4,223 Views
0 Likes
11 Replies
LanBiteam
Partner - Contributor III
Partner - Contributor III
‎2020-12-03 10:40 AM

In response to Tomas_Sommergyll

Hi Tomas,

we have updated to Connecotr 7.0.4 and QlikView April 2020 SR2, then there is the same problem. Can you suggest how can I troubleshoot? From SAP side we have already confirmed the report. 

Thanks, 

Lan

374 Views
0 Likes
Tomas_Sommergyll
Employee
Employee
‎2020-12-09 08:24 AM

Hi,

Unfortunately, the Report Connector is unable to handle all sorts of reports from the generated spool files, as report layouts can vary from being simple to very complex.  The "Mismatch detected" - message is the generic error for when the connector is unable to figure out the layout based on the information in the spool files. 

Link to support page describing this message: https://support.qlik.com/articles/000021738

 

Best regards,

Tomas

353 Views
0 Likes