Qlik Community

QlikView Deployment

Discussion Board for collaboration related to QlikView Deployment.

Announcements
QlikWorld 2020: Join us May 11 - 14, 2020 in Phoenix, AZ. Register early and save $400. Learn More
Highlighted
Not applicable

Access point not loading after IIS update and Qlikview reinstall

Hi all,

We had Qlikview Server installed and working properly in a Windows Server 2012, with IIS 6.

We recently updated the IIS to 8, and Qlikview web pages stopped working (both Access point and management).

We uninstalled and reinstalled Qlikview, and it started to serve web pages again. Management page is working, but Access Point doesn´t load, it freezes while loading content.

The aplication pools in IIS are .NET 4. ¿Could it be some issue with javascript, or maybe a permission issue ¿?

Could you please help us?

Thank you very much,

Tags (3)
Labels (2)
5 Replies
Employee
Employee

Re: Access point not loading after IIS update and Qlikview reinstall

As long as I know only IIS6 and IIS7 are supported.

My manual says at System Requirement page:

Web server QlikView Web Server  (QVWS) Microsoft IIS 6 and 7

QlikView Web Server  (QVWS) Microsoft IIS 6 and 7

Support
Support

Re: Access point not loading after IIS update and Qlikview reinstall

IIS 8 is the default for 2012 server and it should work. I have it running on my test system.

Bill

Bill - Designated Support Engineer at Qlik
To help users find verified answers, please don't forget to use the "Accept as Solution" button on any posts that helped you resolve your problem or question.
Not applicable

Re: Access point not loading after IIS update and Qlikview reinstall

What should I check so that Javascript works? It seems my problem could be a javascript issue.

Support
Support

Re: Re: Access point not loading after IIS update and Qlikview reinstall


I would check to make sure that the roles and feature installed is correct.

You can put the below in a .bat file and run it and it will install the items needed.  When you run it a CMD window will come up and when in goes away you are set to go. You can also check your setup to make sure each of the below is installed.

start /w pkgmgr /iu:IIS-WebServerRole;IIS-WebServer;IIS-CommonHttpFeatures;IIS-StaticContent;IIS-DefaultDocument;IIS-DirectoryBrowsing;IIS-HttpErrors;IIS-ApplicationDevelopment;IIS-ASPNET;IIS-NetFxExtensibility;IIS-ASP;IIS-ISAPIExtensions;IIS-ISAPIFilter;IIS-HealthAndDiagnostics;IIS-HttpLogging;IIS-RequestMonitor;IIS-Security;IIS-WindowsAuthentication;IIS-RequestFiltering;IIS-IPSecurity;IIS-Performance;IIS-HttpCompressionStatic;IIS-WebServerManagementTools;IIS-ManagementConsole;IIS-ManagementScriptingTools;IIS-ManagementService;IIS-Metabase;IIS-WMICompatibility;IIS-LegacyScripts;IIS-LegacySnapIn;WAS-WindowsActivationService;WAS-ProcessModel;WAS-NetFxEnvironment;WAS-ConfigurationAPI

Bill

Bill - Designated Support Engineer at Qlik
To help users find verified answers, please don't forget to use the "Accept as Solution" button on any posts that helped you resolve your problem or question.
Partner
Partner

Re: Access point not loading after IIS update and Qlikview reinstall

Hi, this is an old topic and I'm sure that the issue has ben fixed, but still worth asking. Since you're using Windows Server 2012, did you checked that .NET 4.5 was installed in the Server Roles as well as the Windows Authentication feature?

Regards