Qlik Community

QlikView Deployment

Discussion Board for collaboration related to QlikView Deployment.

ipauldur
Contributor

Always one Selected not working

Hi,

I have macro to set the properties "AlwaysOneSelectedValue" is true . This is working fine in Qlikview version 9.

Recently, we have upgraded the version 9 to 10 SR3 9061 build version. After that, this macro is not working when i access the application through IE. If i open in the desktop version still its working fine.

Anybody aware of this behaviour?..

Thanks,

Durai.

4 Replies

Always one Selected not working

Hi,

You can do the same without a macro.

Select a single values from the list box.

Right clik on it go to properties an in general tab, select the check box "always one value selected".

hopefully this will help you out.

Regards

ASHFAQ

ipauldur
Contributor

Always one Selected not working

Hi Ashfaq,

Sorry, i know that. But i want to do through macro. Because, this is not a permanent selection for particular field. When we move to other sheet, need to unselect this "Always One Selected Value" due to select more than one value of that field. So i want to handle through macro..

Thanks for your reply..  Any other suggestions?

Regards,

Durai.

ipauldur
Contributor

Re: Always one Selected not working

Hi Ashfaq,

Sorry, i know that. But i want to do through macro. Because, this is not a permanent selection for particular field. When we move to other sheet, need to unselect this "Always One Selected Value" due to select more than one value of that field. So i want to handle through macro..

Thanks for your reply..  Any other suggestions?

Regards,

Durai.

erich_shiino
Honored Contributor

Always one Selected not working

Hi,

Durai, You can only set this if there is only one value selected already.

Maybe your problem is one step before the one you reported.

Can you share your script with us?

Regards,

Erich