Qlik Community

QlikView Deployment

Discussion Board for collaboration related to QlikView Deployment.

Not applicable

Frequent "Message:No Server" on Access Point (QV 11 SR2)

Hi all,

  We had recently upgraded to QV 11 SR2 from QV 10. We are now facing frequent "No Server" issues on the access point. There have been no changes in the hardware or number of reports on the server after the upgrade. Things used to work fine with QV10 but now we are facing a lot of issues. Any suggestions on where the problem could lie?

Thank you.

PS: Sorry if this is not the right community for server related issues.

1 Reply
erich_shiino
Honored Contributor

Re: Frequent "Message:No Server" on Access Point (QV 11 SR2)

Hi,

This is more like this forum: http://community.qlik.com/community/deployment?view=discussions&start=0

but I don't think this is a problem.

I haven't seen this message on the accesspoint but I saw it at QMC.

In my case, I believe that when the server is busy in a very heavy load, it takes longer to answer QMC and it triggers some kind of timeout.

In my case, the messages were just anoying.

So, I also want to understand? Is it just a timeout? Can it be adjusted to avoid the message ?

Regards,

Erich

Community Browser