Qlik Community

QlikView Deployment

Discussion Board for collaboration related to QlikView Deployment.

Not applicable

Problem with NT security while accessing dashboards through Access Point

Hi,
We have a HR dashboard built and distributed through Publisher. The report has section access security (data restriction through NT) embedded in it.
I am part of the distribution list in the publisher, as well I am part of the section access data. I am able to see the dashboard in the Access Point but when I try to open the document its prompting me for an User ID/pwd rather than recognizing my NT ID.
Even if I key in my NT User ID and pwd details, the report is still prompting for User ID and password. I tried using the backdoor user id and password, but still its prompting for User ID and password.
This scenario applies to all the Users who are all part of the HR dashboards.
I have attached the screenshots from the access point as well as the report prompting.
When I open the local copy of the document and use the backdoor user id and pwd, the document is opening fine.
Any thoughts???
Thanks & Regards
Raja
3 Replies
Not applicable

Problem with NT security while accessing dashboards through Access Point

I had a similar issue caused by having no section access in the document and a checkmark in the option "Initial Data Reduction Based on Section Access" in the Opening tab of Document properties.

Jay

Not applicable

Problem with NT security while accessing dashboards through Access Point

Jay,

I have the option (Initial Data Reduction) enabled in my document, as I have section acess.

The NT security is not working both ways (by enabling or disabling).

Raja

Not applicable

Problem with NT security while accessing dashboards through Access Point

Hi Jay,

I have the same problem!

Did you find a solution.

Darren