Qlik Community

QlikView Deployment

Discussion Board for collaboration related to QlikView Deployment.

Announcements

Breathe easy -- you now have more time to plan your next steps with Qlik!
QlikView 11.2 Extended Support is now valid through December 31, 2020. Click here for more information.

jaymerry
Not applicable

Qlikview 11 Accesspoint "loading content"

Hello all,

Qlikview 11 has been installed in our server instead of Qlikview 10.

After the installtion, all the services seem to be ok :

However, when when I try to go on the accesspoint, I have the following message :

Have you got any idea of this problem ?

Thanks for your help,

Best regards,

Jaymerry

1 Solution

Accepted Solutions
Support
Support

Qlikview 11 Accesspoint "loading content"

There is a couple of things that will cause this. The first  thing to check is to make sure that the QlikView IIS  application pool is set for .net V4.  If not set it and try again. If that doesn't work then run this command

C:\Windows\Microsoft.NET\Framework64\v4.0.30319\aspnet_regiis.exe -i and go back check step one.

Bill - Designated Support Engineer at Qlik
If a post helps to resolve your issue, please mark the appropriate replies as CORRECT.
56 Replies
jaymerry
Not applicable

Qlikview 11 Accesspoint "loading content"

Here a screenshot of the accesspoint message :

loading.png

Thanks,

hsymomos
Not applicable

Re: Qlikview 11 Accesspoint "loading content"

Hi Jaymerry,

The .Net 4 is a required in the QV11 installation.

You'd better install the .Net 4 framework before installing the QlikView server.

Hope this helps.

p_verkooijen
Not applicable

Re: Qlikview 11 Accesspoint "loading content"

.NET 4 framework is a requirement for QV11, so this should not be the issue.

  • Are you using IE / Chrome / iPad / Mobile access
  • What is your authentication type
Not applicable

Re: Qlikview 11 Accesspoint "loading content"

I have the same issue while using a mobile browser on an android phone and while using Firefox on a windows 7 machine, chrome and IE are fine.

jaymerry
Not applicable

Qlikview 11 Accesspoint "loading content"

Hello all,

I'm trying to go on the access point with IE, on windows 7.

.NET 4 framework is installed ; the authentification type is Ntml..

Have you any idea of this problem ?

Thanks for your help

Stefan_Bäckstrand
Not applicable

Qlikview 11 Accesspoint "loading content"

Are you running IIS or QvWebServer? Is the QVS service reporting OK in the QMC? Can you use "Open in Server" from a Developer/Desktop client and get a document list and open documents? Have you tried starting Fiddler (www.fiddler2.com) web debugging tool to see if you get any error responses back from the web server?

Not applicable

Qlikview 11 Accesspoint "loading content"

Hello,

Sometimes I've got the same problem.

The page is not loading and keep showing "Loading Content".

We are using a reverse proxy and we are suspecting that this may cause the problem.

Regards

Kevin

Not applicable

Qlikview 11 Accesspoint "loading content"

Hi all,

I also had this problem with QV11 using IIS.

The problem was solved by using the qlikview webserver instead of IIS.

I suppose there was in the IIS configuration. But, as using the QV webserver is ok for me, I don't search the exact problem.

Not applicable

Qlikview 11 Accesspoint "loading content"

In the url try with the IP address instead of server name