Qlik Community

QlikView Deployment

Discussion Board for collaboration related to QlikView Deployment.

Not applicable

Report working fine on server but not on Access Point

Hi Experts,

When I opened an application  on SERVER it working fine but when I tried to open it with ACCESSPOINT it gives me some null values.

Section access is applied.

I am using QV11.2 SR5

BR,

Anta

1 Solution

Accepted Solutions
Not applicable

Re: Report working fine on server but not on Access Point

The issue has been resolved.. issue was due to one of the filter, that filter was applied on section access.

11 Replies

Re: Report working fine on server but not on Access Point

Is there any section access within the application?

- Marcus

Not applicable

Re: Report working fine on server but not on Access Point

yes, we are using section access.

MVP
MVP

Re: Report working fine on server but not on Access Point

Then it is possible that data reduction is causing some expressions to return null values.

Not applicable

Re: Report working fine on server but not on Access Point

ok.. but same copy of document working fine on server and causing problem when we try to open it with Access Point

MVP
MVP

Re: Report working fine on server but not on Access Point

You may be opening it with ADMIN access when you open it on the server - I assume that you are using QV desktop on the server?

When you open in the access point, you are opening in USER mode, regardless of your access level in the section access script.

qlikviewnovice
Valued Contributor II

Re: Report working fine on server but not on Access Point

It will happen if you use Section Access because of Data Reduction. May be you logged as Admin in server where as you logged in as User in Access Point so that you are getting these Null Values.

Not applicable

Re: Report working fine on server but not on Access Point

NO, in both the access I am using my own ID...

Not applicable

Re: Report working fine on server but not on Access Point

NO, in both the access I am using my own ID... I am access server by using RDP access

Re: Report working fine on server but not on Access Point

Are you really sure? Put a textbox with osuser() and qvuser() in the application and look if they return on server and access point the same results.

- Marcus