Qlik Community

QlikView Deployment

Discussion Board for collaboration related to QlikView Deployment.

Not applicable

Select one value works on developer tool but not on server

I am using the same list box on separate sheets. On one sheet, I want to allow all selections, so I use an alternate state such as all_values. On another sheet, I want to limit the selection on the same list box to one selection, so I check "only select one value" and use alternate state one_value. This works well in the developer tool. But when I put it on the server, it allows to select more than one value on both list boxes. Why would it act differently on the server?

Labels (1)
1 Solution

Accepted Solutions

Re: Select one value works on developer tool but not on server

Hi,

What version Of Qlik You use?

I tried with 11.2 sr6 and it worked fine.

I believe you need to look at QlikView upgrade.

Regards

ASHFAQ

Regards

ASHFAQ

5 Replies
xufei123
Valued Contributor

Re: Select one value works on developer tool but not on server

Try setting a trigger in the document setting. When opening this application, one default value in that field with "one_value" alternate state will be selected.

Fei

parthiband
Contributor

Re: Select one value works on developer tool but not on server

Hi Mike,

Think, these 2 posts will you understand the problem and will make u arrive to the solution.

QlikView Maven: Always One Selected Value Really

Read also the comments..

Re: Always one selected value on Access point

Thanks

Re: Select one value works on developer tool but not on server

Hi,

What version Of Qlik You use?

I tried with 11.2 sr6 and it worked fine.

I believe you need to look at QlikView upgrade.

Regards

ASHFAQ

Regards

ASHFAQ

bellamae
Valued Contributor

Re: Select one value works on developer tool but not on server

Hi Mike

I have struck this with radio buttons, for some reason if no selection is made when you save it to the server it wipes the "only select one value" gets wiped so you need to reset it in the server copy but be aware to set it you will have to have a single option chosen.

Bella

Not applicable

Re: Select one value works on developer tool but not on server

The problem went away when I upgraded to 11.2.  I also found that when I placed a new copy of the .qvw file on the server, that I needed to completely close Internet Explorer/Access Point and re-open it before I would see the problem go away.

Community Browser