Qlik Community

QlikView Extensions

Discussion Board for collaboration on QlikView Extensions.

Announcements

Breathe easy -- you now have more time to plan your next steps with Qlik!
QlikView 11.2 Extended Support is now valid through December 31, 2020. Click here for more information.

mvluttge
New Contributor III

QV-User-Manager

Hi,

I have several large clients where I would like to use this PowerTool for managing CALs on the QlikView server, but I can't seem to decipher how to put the syntax together correctly.

I have connection to the QlikVIew server through the qv-user-manager.exe and have successfully gotten a list of users, both in the command-prompt and as a .csv-file.

I would now like to try to assign a CAL to a specific user and a specific document. As far as I can see in the readme-file, the syntax should go something like this:

qv-user-manager.exe -a=CAL -d=QlikViewDocument.qvw

...and that is as far as I can get. How do I define which specific user (i.e "domain1\user1") I would like to assign a document CAL for document "QlikViewDocument.qvw" to?

Best Regards,

Martin

1 Solution

Accepted Solutions
g_westaway
New Contributor III

QV-User-Manager

Hi Martin,

You might like to refer to this one as I had the same issue:

http://community.qlik.com/message/184788#184788

2 Replies
g_westaway
New Contributor III

QV-User-Manager

Hi Martin,

You might like to refer to this one as I had the same issue:

http://community.qlik.com/message/184788#184788

haggroth
New Contributor II

QV-User-Manager

Hi Martin,

check my reply in the above thread.

/Daniel