What I want is to display the european map with the name of the countries on my document, however, it seems to not recognize my ISO extensions, even after I get doing SubField([ISO 3166-2 Sub-division/State Code],'-',2) as [Regional ISO Code] in the code, which allows me to have the extension for the subdivisions.
Does anyone have any experience on this and the way to treat it?
thanks a lot!!
P.S.:I left the links so it can help people getting further in the development.
P.S.2: i'm not sure if it's the write place to post my question, so don't hesitate to move it to the correct place if needed
I was able to get the map extension to work - at lease with a limited amount of data. Seemed to work great, but, when I reloaded with the full data set, the map became unstable. I have two tabs, both using the map, but with different calculations on each. When I switch between the tabs, sometimes the map populates with the data and sometimes it doesn't. I think it may be that it is too slow, and it takes a while for the data to populate. Not sure. Has anyone else experienced this?