Qlik Community

QlikView Layout & Visualizations

Discussion Board for collaboration on QlikView Layout & Visualizations.

divya_anand
Contributor II

Drill down not working as expected

Hi all,

I have an issue working with Drill down group. There are 4 stages in my application R1->P1->C1->E1.

When I make selection within the bar chart and when I want to drill up E1->C1->P1->R1->, everything is working fine.

However, if I have to make selections using a list box for R1, P1, C1 & E1, I am not able to drill up from C1->P1.

Why is this?

3 Replies
MVP
MVP

Re: Drill down not working as expected

I can't reproduce this easily.

Could you post a small sample QVW that demonstrates your issue?

There might be an issue if your selections are limiting your record set to one possible value for P1, so you will get drilled down to C1 level automatically, but I don't think this behaviour is depending on where you are making your selections.

Re: Drill down not working as expected

Drill down can skip a level if there is only a single value returned.

For example if your selections on R1, P1, C1 and E1 return a single result for P1, your chart will drill from R1 > C1 > E1 skipping the P1 level as it is a single result

divya_anand
Contributor II

Re: Drill down not working as expected

Hi,

Thank you all for your responses. There was a mistake in the dimensions I chose, my bad.

Community Browser