Discussion Board for collaboration on QlikView Layout & Visualizations.
I would like No data to display to read: "You must select Clinical for this chart to display"
Go to Solution.
Go to Chart Properties -> General -> In Calculation Condition-> GetSelectedCount(Your Dimension)=0
Select Error Message Tab -> Select ->Calculation Condition Unfulfilled-> Type Message
"You must select Clinical for this chart to display"
Hope this helps you
Hi all - I found an answer as suggested by Marco Wendell.
I used a transparent text box with an if statement:
if(Classification <> 'Clinical', 'Tumour Stream is from Utilisation - Please select Clinical Classification')
I have put in a link to the answer but not sure it will work
yes, it will work. You can do it two way one is as mentioned Vikas Mahajan and one more using the test box (hide and showing conditions using the layout) ....
NOTE: if you need images in the error msg then Vikas logic will not work , you need to make use of the text box only
Thank you both ways worked
Cool, can you please mark the correct answer and close this thread, so that it will be helpful for others too
Hi - how do I do this???? I cannot find "correct answer"