I would like to know if it is possible to make that the second segment of the Linear Gauge in Straght Table moves according to the dimension of the straight table.
In the example that I enclose you can see that the values of the colored segments are always the same, but if I click on a value of Priority updates.
Sorry, but I don't understad your "Yes".
In the example the segments are the same in the four value of the dimension Prioriy, but for me it's no right.
I want that the second segment begin where is the arrow and if I qlik on one value of the dimension it works.
See the picture
I'm not sure to have understood well what you need, but if you want to change the size of the red part or/and green part, you can do it.
For that go to "Properties" of the graphic then in the label "Expression" you click on parameters of the gauge and then uncheck "automatic width of segments" and then you can use a fix number or calculate the size of each segment.
I have done this, but I think that the gauge calculate the average and not the single value for each value of the dimension.
In then example I have this:
but I would like this one:
and this is the properties: