Discussion Board for collaboration on QlikView Layout & Visualizations.
I have an issue
I created drill down ,when i added this in to chart its not working
I have 4 levels,directly its applying level2 in chart
i am not getting level1 in my chart ,its showing directly in level2
Please some one help me
Thanks In Advance
Go to Solution.
So if you drill on 'allocations out' in 'Account rollup 3' it will jump straight to Acct 3 because the 2 levels between just have 1 value
It could be that only 1 value is in the top level , or your current selections have filtered it down to 1 value.
Drill down groups will auto-drill down when there is only 1 value... just as if you clicked the 1 value to drill down.
is there data for level 1? A sample application would help.
I agree but in middle also its giving problem,
But in this im not getting Acc3,its going directly Acct4
Any Suggestions please
it would be the same behaviour whether its a single value in the top or middle, it will auto-drill to the level beneath until you encounter a level with more than 1 value, or you reach the bottom.
is this consistent with what you are seeing ?
try creating a pivot table with the 4 levels and checking that your drill path you are testing has 1 or more values where it appears to jump an extra level (or more) down.
Please find the sample application
Your group was in the wrong order (see attached app);
I don't like drill groups. You all know why.
Use a cyclic one instead.
Again Im getting same results only
any other ideas