Qlik Community

QlikView Layout & Visualizations

Discussion Board for collaboration on QlikView Layout & Visualizations.

t_witzgall
New Contributor III

legend disappears after picking selection criterion

Hello,

I have made two charts where you can decide between three selection criterions:

If I pick one of the criterions the others disappear:

and reappear after clicking anywhere on the chart:

The charts both have two dimensions. One is a bar chart the other a line chart. The dimensions are the same for both.

I tried to choose another chart type but that didn't have any effect.

When I rearrange the legend on the left or right side so that the criterions are standing one below the other it works correctly. Unfortunately I need it to be at top and the criterions to stand in one line.

I tried to make the legend bigger but the only effect was a smaller graph.

Does anyone have an idea what could be wrong here and how to fix it?

Thanks for any help!

Regards,

Tamara Witzgall

Tags (3)
1 Solution

Accepted Solutions
t_witzgall
New Contributor III

Re: legend disappears after picking selection criterion

Just in case somebody has the same issue:

I made the whole diagram a bit bigger and now it works. So probably QV hadn't had enough space to show it. Why it reappeared when clicking somewhere else will remain a mistery

1 Reply
t_witzgall
New Contributor III

Re: legend disappears after picking selection criterion

Just in case somebody has the same issue:

I made the whole diagram a bit bigger and now it works. So probably QV hadn't had enough space to show it. Why it reappeared when clicking somewhere else will remain a mistery

Community Browser