Qlik Community

QlikView Layout & Visualizations

Discussion Board for collaboration on QlikView Layout & Visualizations.

Not applicable

traffic light gauge

Hi,

I am creating a traffic light gauge,

but I have only 2 segment, red (<50) and green (>50).

how can i make the middle light to stay always grey?

the idea is to make a list of gauge to always display consistently 3-bubble.

Thanks.

Tags (1)
1 Solution

Accepted Solutions
multiview
Contributor II

Re: traffic light gauge

What I understand is that you would like to show traffic lights based on the value as follows :

Less than 50     -> Red

Equal to 50        -> Grey

Greater than 51 -> Green

If this is your requirement, then here is how to achieve it.

1 - I have put min vlaue 0, max value 100.

2 - Created 3 segments

3 - All options of Guage properties are un-checked except 'Relative segment bounds'

4 - Put 0,0.5, 0.51 as lower bounds respectively.

5 - Click OK

This should show red light for values less than 50, grey for 50 and green >50.

I hope this helps!

Regards

MultiView

1 Reply
multiview
Contributor II

Re: traffic light gauge

What I understand is that you would like to show traffic lights based on the value as follows :

Less than 50     -> Red

Equal to 50        -> Grey

Greater than 51 -> Green

If this is your requirement, then here is how to achieve it.

1 - I have put min vlaue 0, max value 100.

2 - Created 3 segments

3 - All options of Guage properties are un-checked except 'Relative segment bounds'

4 - Put 0,0.5, 0.51 as lower bounds respectively.

5 - Click OK

This should show red light for values less than 50, grey for 50 and green >50.

I hope this helps!

Regards

MultiView

Community Browser