Qlik Community

QlikView Management

Discussion Board for collaboration on QlikView Management.

Announcements
QlikWorld 2020: Join us May 11 - 14, 2020 in Phoenix, AZ. Register early and save $400. Learn More
tsyganov_av
New Contributor

Change default timeout on trigger

Hello all,

is there a way to change default timeout from 1440 to a different value?

I know that it can be done manually, by selecting a task and changing the value, but I want to set different value to be default for all new tasks?

Best regards

8 Replies

Re: Change default timeout on trigger

Which timeout where? Session timeout, document timeout, object timeout?

tsyganov_av
New Contributor

Re: Change default timeout on trigger

Good afternoon, clarification in the attached file.

HirisH_V7
Honored Contributor

Re: Change default timeout on trigger

Is it not allowing to do so?

HirisH
“Aspire to Inspire before we Expire!”
tsyganov_av
New Contributor

Re: Change default timeout on trigger

Good afternoon. I need something to default this value was 120 minutes. this is Due to the fact that QMC is divided into zones, and in each zone there is a list of people who creates and runs the Task, without changing this parameter. Task is usually performed within 2 minutes, in case of an error it will hang for 1440 minutes.

Support
Support

Re: Change default timeout on trigger

Hello,

You should be able to set the global task timeout to a value of your choosing in the %ProgramFiles%\QlikView\DistributionService\QVDistributionService.exe.config file. Try the following:

  1. On the server running the QlikView Distribution Service (QDS), stop QDS
  2. In Windows File Explorer, navigate to %ProgramFiles%\QlikView\DistributionService and open the QVDistributionService.exe.config file for editing
  3. Search for <add key="AbsoluteMaximumMinutesBeforeTaskTimeout" value="1440"/>
  4. If this key is present, set the key to the desired value.
  5. If this key is not present, enter the key under the <!-- ************ QlikView Engine and Distribution Settings ************ --> portion of the file, and set the key to the desired value.
  6. Restart QDS


Hope this helps,

Chip

Sr. Technical Support Engineer with Qlik Support
tsyganov_av
New Contributor

Re: Change default timeout on trigger

Good afternoon.

Sorry for the delay in answering.

This setting gave no results.

Stopped the service, added option launched service, the result is in the screenshot.

The directory may need to brush?

123.JPG

tsyganov_av
New Contributor

Re: Change default timeout on trigger

Chip Matejowsky, good afternoon. Check out the correctly added line in my screenshot? Anything else you need to do?

Support
Support

Re: Change default timeout on trigger

Hey, if this global setting in the QVDistributionService.exe.config isn't working for you, suggest you contact Qlik Support for further assistance.

Sr. Technical Support Engineer with Qlik Support