Qlik Community

QlikView Management

Discussion Board for collaboration on QlikView Management.

schillo87
New Contributor II

Document Task with Section Access

Hi,

I've a qvw with Section Access into Hidden Script:

TabellaUserNeg:

LOAD

     ACCESS,

     NTNAME,

     NTDOMAINSID,

     COD_NEG

FROM

[http://HOST:4780/QMS/AuthTable]

(html, utf8, embedded labels, table is default);

Section Access;

LOAD ACCESS,

     NTNAME,

     COD_NEG

Resident TabellaUserNeg;

Section Application;

In qmc into Users/"Section Access Management" I've a default table with 4 users and 1 admin. These users matches with the intranet domain users. Admin is a local admin user.

So, If I open the qvw from Access Point it works and the users see their data correctly. But, If I set a Document Task into qmc with the Reduce Field COD_NEG and Distribute Recipient NTNAME, it doesn't work fine. It doesn't create a qvw file for each COD_NEG. Because the user that runs this task is Administrator, and Administrator has no COD_NEG value. (see below)

Can I set a bypass security with Administrator user?

My goal is run a qmc task and distribute it the right users splittin the file for each COD_NEG (and Administrator must see all the data when I run the task)

My User Table:

ACCESSNTNAMENTDOMAINSIDCOD_NEG
ADMINADMINISTRATORSRVMQLIK01
USERUSER1INTRANET1
USERUSER2INTRANET5
USERUSER3INTRANET20
USERUSER3INTRANET5

Thank you very much, best regards!

Riccardo

Community Browser