I have installed my Qlikview applications on Qlikview Server.And accessing them from a cleint machine. Sometimes my access point is comming fine and applications are also running fine but sometimes "Internal Error - Server Connection Terminated" Comes on the page and access point is not displayed.
Does somebody has an answer to this. i am also attaching a screen shot.
I am using QvWebServer but IIS is also installed on my server.
I have cleared the logs and aging tried to open the Access Point through the URL. Again i am getting the same error and in the QvWebServer logs only these lines were printed.
2/13/2012 17:16:51.9849756 Information Request received [POST]: http://<Server IP:Port>//qvws.asmx
2/13/2012 17:26:52.0041756 Information Request received [POST]: http://<Server IP:Port>//qvws.asmx
My access point was comming for some time but when i stopped the IIS, access point also stopped comming, blank page was comming and now when i have started it again access point is comming in a distorted way. i have atached a screen shot of it also.
Ok, so again - which one are you supposed to use in this configuration - QvWebServer or IIS? It's one or the other, not both. If you want to use IIS, then QvWebServer needs to be stopped, and vice versa.
Also, it seems you are accessing the AccessPoint via the IP-address - it's better to use DNS hostnames. Is there a reason for not doing this?
Actually i am not using any of them intentionally . i think QvWebServer is used as default. Can u suggest me if how to use any one of them explicitely.
When i am using computer name instead of ip address in am not able to access the url.
i think using IP is more appropriate than using computername.
Ok. If you are supposed to use QvWebServer, you need to stop IIS. At least make it not respond to port 80.
Regarding hostnames.. best practice is always to use DNS or NetBIOS hostnames. It is also the way the QlikView service interfaces are configured by default, and using IP instead can cause issues like you are seeing. If you cannot access AccessPoint via hostname, the fault is probably in your environment/machine rather than in QlikView.
Consult your IT people if you have DNS name resolution issues or alike.
i tried to open access point by hostname but it is not openiing up. then i went on the server and tried to open the access point by local host it opened , then i tried by sever IP it opened but when i tried by local host it again didn't open on server also.
I think the IIS is using port 80 can u tell me how to make it not respond to port 80. also does port 4747 also have any significanse in this.
To shut down IIS, do either of the following two:
1. Start > Run.. > cmd > net stop W3SVC.
2. Start > Run.. > services.msc > World Wide Web Publishing Service > Stop.
You might also want to change the service startup mode to "Manual" or "Disabled" to stop it from restarting and causing issues again.