Qlik Community

QlikView Management

Discussion Board for collaboration on QlikView Management.

vireshkolagimat
Contributor II

Qlikview task failed!!!

Hello All,

I have scheduled the a task in QMC but sometimes i got the below error message and it will run fine without any fix next time.

Any idea what might be happening?

Thank You.

The task "QlikviewApp/Retail Distribution Oracle/Extraction/04_Fsd_Qvd_Generator.qvw" failed. Part of the log file follows:

14/01/2018 03:21:38 AM Error The Source Document was NOT reloaded successfully. DocumentPath=E:\QLIKVIEWAPP\Retail Distribution Oracle\Extraction\04_Fsd_Qvd_Generator.qvw.
14/01/2018 03:21:38 AM Error The task "QlikviewApp/Retail Distribution Oracle/Extraction/04_Fsd_Qvd_Generator.qvw" failed. Exception: QDSMain.Exceptions.TaskFailedException: Task execution failed with errors to follow. ---> QDSMain.Exceptions.ReloadFailedException: Reload failed ---> QDSMain.Exceptions.LogBucketErrorException: The Source Document was NOT reloaded successfully. DocumentPath=E:\QLIKVIEWAPP\Retail Distribution Oracle\Extraction\04_Fsd_Qvd_Generator.qvw. at QDSMain.ReloadTask.VerifyConditions(TaskResult taskResult) at QDSMain.ReloadTask.Reload(String fileName, TaskResult taskResult, String sectionAccessUserName, String sectionAccessPassword, eReloadOptions reloadOption, String variableName, String variableValue, Boolean moniterCpuUsage) --- End of inner exception stack trace --- at QDSMain.ReloadTask.Reload(String fileName, TaskResult taskResult, String sectionAccessUserName, String sectionAccessPassword, eReloadOptions reloadOption, String variableName, String variableValue, Boolean moniterCpuUsage) at QDSMain.DistributeTask.Execute(TaskResult currentTaskResult) --- End of inner exception stack trace --- at QDSMain.DistributeTask.Execute(TaskResult currentTaskResult) at QDSMain.Task.AbstractTask.TaskExecution(ILogBucket logBucket, TaskResult taskResult)

4 Replies
uacg0009
Valued Contributor

Re: Qlikview task failed!!!

Hi Viresh,

Have you opened the log file of this qvw?

If you did, could you please show the qvw log of failed? I think that's better to check the problem.

Thanks.

Aiolos

antonaks
Contributor II

Re: Qlikview task failed!!!

Have you set a Section Access attributes in QMC options?

vireshkolagimat
Contributor II

Re: Qlikview task failed!!!

I will check it. thanks

Re: Qlikview task failed!!!

If you can't find a DocumentLog.txt file (in the log folders of the Distribution Service) or a 04_Fsd_Qvd_Generator.qvw.log in the folder of your document, then you may have to enable log file generation in your document. Enable Settings->Document Properties->General->Generate Log File, save and reload (or wait for the next reload failure, if the problem occurs intermittently.)

Community Browser