Qlik Community

QlikView Management

Discussion Board for collaboration on QlikView Management.

ali_hijazi
Honored Contributor

SSL in QV 1.2 SR5

We are working on QlikView Server 11.2 SR5

we want to force communication over HTTPS protocol

we have the certificate and we register it using NETSH command successfully

I checked the use https in QMC and put 443 in the port

However no one is able to log in to Access point using https

is there any step missing?

Please advise

4 Replies
Employee
Employee

Re: SSL in QV 1.2 SR5

Hi Ali,

One of the issues I have seen over and over is that people do the bindings wrong. This has to be ipport=0.0.0.0:443 you don't put an IP address there.

Bill

erikadvectas
Valued Contributor

Re: SSL in QV 1.2 SR5

Hello Ali,

Have a look at Enable SSL - QlikView Webserver

Might help you out!

Regards,

Erik

ali_hijazi
Honored Contributor

Re: SSL in QV 1.2 SR5

ah that's it

I put the up address

what procedure shall I follow to correct this mistake?

Employee
Employee

Re: SSL in QV 1.2 SR5

You will need netsh http delete sslcert ipport= the ip you used:443

Then redo it with ipport=0.0.0.0:443

Bill

Community Browser