Qlik Community

QlikView Management

Discussion Board for collaboration on QlikView Management.

Not applicable

Unable to Assign Doc Cal on Test Server

We have a qlikview test server v11 and I am currently unable to allow users to view the document via Document CAL's. The documents are not even visible on the access point to those with document cals. The problem does not occur for those with Named User Licenses. I notice that after assigning the documents it reads "Document CALs assigned to users: 0" int Document Cal Summary (picture attached). Any ideas?

Thanks!!!

Marc

doc cal problem.png

Tags (2)
1 Solution

Accepted Solutions
Not applicable

Re: Unable to Assign Doc Cal on Test Server

I was able to fix the problem. The security settings in the management console were set to NTSF which means that the appropriate window security permissions need to be set by right clicking the qvw document/folder and adding the appropriate user groups. It appears that in order for qlikview management console to control permissions the user group "authenticated users" must be given "read" security permissions.

3 Replies
rajni_batra
Valued Contributor

Re: Unable to Assign Doc Cal on Test Server

It doesn't matter with above 0 that u marked wid red its coming 0 bcoz there is no last used log for both d user u assigned with DOC CAl once u will be able to open d app with doc cal user it will alos get updtaed.

.. have you applied section access also to your document ? if yes then add these 2 users to section access list also,

Not applicable

Re: Unable to Assign Doc Cal on Test Server

Thanks for the response! I looked at document settings and as far as I know, I do not have any kind of section access enabled. However, it does seem to be some sort of section access problem because users cannot see any of the documents on the test server.

Thanks,

Marcus

Not applicable

Re: Unable to Assign Doc Cal on Test Server

I was able to fix the problem. The security settings in the management console were set to NTSF which means that the appropriate window security permissions need to be set by right clicking the qvw document/folder and adding the appropriate user groups. It appears that in order for qlikview management console to control permissions the user group "authenticated users" must be given "read" security permissions.

Community Browser