Qlik Community

QlikView Management

Discussion Board for collaboration on QlikView Management.

Not applicable

Where to get "No. of retries" option for autoreloads in QMC

Hi All,

Where can I find the "No. of retries" option for autoreload tasks in QMC if the task fails due to some reason ?

Using this option, the failed task will start automatically again.

Regards,

1 Solution

Accepted Solutions
Support
Support

Re: Where to get "No. of retries" option for autoreloads in QMC

Hi,

Here it is if you have publisher.

11.20 SR5-2014-08-26-08-50-45.png

Bill

Bill - Designated Support Engineer at Qlik
To help users find verified answers, please don't forget to use the "Accept as Solution" button on any posts that helped you resolve your problem or question.

View solution in original post

3 Replies
MVP & Luminary
MVP & Luminary

Re: Where to get "No. of retries" option for autoreloads in QMC

Hi,

If you do have publisher license, when you create a new task for a source document, you will see General, Reload, Reduce, Distribute... and one of the tabs is Triggers. In the lower part of that tab you have the number of attempts and the timeout in minutes for that task.

Hope it helps you.

Regards,

Jagan.

Support
Support

Re: Where to get "No. of retries" option for autoreloads in QMC

Hi,

Here it is if you have publisher.

11.20 SR5-2014-08-26-08-50-45.png

Bill

Bill - Designated Support Engineer at Qlik
To help users find verified answers, please don't forget to use the "Accept as Solution" button on any posts that helped you resolve your problem or question.

View solution in original post

Not applicable

Re: Where to get "No. of retries" option for autoreloads in QMC

Thanks a lot Jagan & Bill

I have read many posts / answers from both of you which has helped me very much.