Qlik Community

QlikView Management

Discussion Board for collaboration on QlikView Management.

Not applicable

i have a table and which to ignore the current selections, clearly set analysis is available when aggregating, but i am not sure how to code this (i could always change my load script to duplicate the data but don't wish to do this as it will hit performa


i have a table and wish to ignore the current selections, clearly set analysis is available when aggregating but i am not aggregating, but i am not sure how to code this (i could always change my load script to duplicate the data but i don't wish to do this as it will hit performance (i thought the show all might do it but it didn't :-()

2 Replies
cheburashka
Contributor III

Re: i have a table and which to ignore the current selections, clearly set analysis is available when aggregating, but i am not sure how to code this (i could always change my load script to duplicate the data but don't wish to do this as it will hit perf

Hello Clive,

Could you provide more information and improve the structuration of your question?

You're question is not inviting Qlikcommunity members to help you out.

For more information about asking questions on Qlikcommunity. I suggest reading the links in the following post:

How does Qlikcomunity work? Questions, Answers and suggestions

,KR Koen

chrismarlow
Contributor III

Re: i have a table and which to ignore the current selections, clearly set analysis is available when aggregating, but i am not sure how to code this (i could always change my load script to duplicate the data but don't wish to do this as it will hit perf

I assume when you say not aggregating you are showing data in a Table (as opposed to Straight Table chart).

Could you have a straight table with all your columns as dimensions, then a dummy expression that returned an aggregation you had used set analysis to ignore the selections on?

Community Browser