Qlik Community

QlikView Publisher

Discussion Board for collaboration on QlikView Publisher.

Not applicable

Failed to load a QVW

Used the "no data" tip but did not work, with Windows Command propmt too.

9 Replies
Not applicable

Re: Failed to load a QVW

Can you explain what is the issue in detail?

I'm not able to open the file

Employee
Employee

Re: Failed to load a QVW

Hi Lakshmi,

Yea, I can't open it either. The size of the document is very small, so I am thinking the document is bad.

Bill

mov
Esteemed Contributor III

Re: Failed to load a QVW

Normally empty QV file is about 150KB.  This one is way too small to be a valid qvw.

Not applicable

Re: Failed to load a QVW

It was more than 500kb to start with and it had successfull run at the end when it is to write to a QVD it failed and then onwards i am not able to open it.

Not applicable

Re: Failed to load a QVW

Did you use section access by any chance?

Not applicable

Re: Failed to load a QVW

no, not sure what it is...

Not applicable

Re: Failed to load a QVW

Hi Lakshmi, do you have a copy of the log file for the document? This would help a lot in determining what the problem is. To set the qvw to create a log file on reload, go to Settings-> document properties -> "general" tab then tick the "generate" logfile checkbox option the right.

See if you can post a copy of the logfile.

Regards

Erica

Re: Failed to load a QVW

Lakshmi


If you open the qvw in a text editor, like notepad, you can can see it looks malformed, normally it should have some human readable xml at the end of the file.


Looks like you'll need to restore a copy from your backups.



Best Regards,     Bill

Employee
Employee

Re: Failed to load a QVW

HI,

If you open a QV and create a new document and just save it the file size is over a 100k. So, I would think there is something wrong with a file that is only 4k.

Bill

Community Browser