Qlik Community

QlikView Publisher

Discussion Board for collaboration on QlikView Publisher.

Announcements

Breathe easy -- you now have more time to plan your next steps with Qlik!
QlikView 11.2 Extended Support is now valid through December 31, 2020. Click here for more information.

salezian
Not applicable

QMSEDX.exe and qvw file

Hi Everyone

I'm trying to run reload of one of my qvw file using qmsedx. But it always ends up with "task not found" error.

I'm launch it using following syntax:

QMSEDX.exe -task=File1.qvw -password=Pass1

What I'm doing wrong ?

regards.

1 Solution

Accepted Solutions
cuv
Not applicable

Re: QMSEDX.exe and qvw file

I´ve copied this command from our server (without Publisher), is working here

QMSEDX.exe -task="Santander/Portal de Relatorios.qvw" -password=!@!!#%%

where

Santander - > is the path

Portal de Relatorios.qvw -> name of qvw

14 Replies
yfe
Not applicable

Re: QMSEDX.exe and qvw file

What is your task name? do you see it properly in the Source Documents tab?

cuv
Not applicable

Re: QMSEDX.exe and qvw file

Probably you have you File1.qvw under a folder, right?

Your path must be in the command line

This path must be QlikView Server root folder relative

mov
Not applicable

Re: QMSEDX.exe and qvw file

If I remember correctly, you have to provide task name, not the qvw file name.

salezian
Not applicable

Re: QMSEDX.exe and qvw file

Yes File1.qvw is under folder. Where can I found QVServer root folder ?

Not applicable

Re: QMSEDX.exe and qvw file

Michael is correct. You need to use the task name as it appears in publisher - do not use spaces - not the qvw file name.

cuv
Not applicable

Re: QMSEDX.exe and qvw file

You must inform root relative.

Check this picture below

"Golf Quest" is /"Golf Quest.qvw"

"Gera QVD - Cronogramas" is "/Extratores/Gera QVD - Cronogramas.qvw"

Capturar.PNG.png

Not applicable

Re: QMSEDX.exe and qvw file

You should type the name of the taskname. So if it is called Reload of file1, then it should be name Reload of file1 - Otherwise rename your taskname

salezian
Not applicable

Re: QMSEDX.exe and qvw file

Thanks for your answers. Quotation from documentation:

"EDX can be used without a QlikView Publisher license. Simply pass the name of the

QVW instead of a task name and the reload schedule of the QVW will run." But still using QMSDEX and providing qvw file as parameter I got error "Task not fount".

Regards.

cuv
Not applicable

Re: QMSEDX.exe and qvw file

I´ve copied this command from our server (without Publisher), is working here

QMSEDX.exe -task="Santander/Portal de Relatorios.qvw" -password=!@!!#%%

where

Santander - > is the path

Portal de Relatorios.qvw -> name of qvw