Qlik Community

QlikView Publisher

Discussion Board for collaboration on QlikView Publisher.

Announcements

Breathe easy -- you now have more time to plan your next steps with Qlik!
QlikView 11.2 Extended Support is now valid through December 31, 2020. Click here for more information.

Not applicable

set category in qlikview publisher

Hello All,

I am working on Qlikiew publisher 11.20 and I have scheduled reports to refresh and store it in a particular folder and set the category in

Document Information.

But when I access the report through Accesspoint, I can see the report in default category and not in the category which is set.

1 Solution

Accepted Solutions
ashfaq_haseeb
Not applicable

Re: Re: set category in qlikview publisher

Hi,

have a look at attached image.

can you see category there in highlighted image.

Regards

ASHFAQ

6 Replies
ashfaq_haseeb
Not applicable

Re: set category in qlikview publisher

Hi,

This works without any problem.

Can you tell what version of Qlik You use?

I tried with 11.2 sr6

Regards

ASHFAQ

Not applicable

Re: set category in qlikview publisher

I am working on 11.20.12354.0 qlikview publisher version.

Bill_Britt
Not applicable

Re: set category in qlikview publisher

Hi Rupali,

In the QMC under User Documents does the category show up there?

Bill

Bill - Designated Support Engineer at Qlik
If a post helps to resolve your issue, please mark the appropriate replies as CORRECT.
ashfaq_haseeb
Not applicable

Re: Re: set category in qlikview publisher

Hi,

have a look at attached image.

can you see category there in highlighted image.

Regards

ASHFAQ

Not applicable

Re: set category in qlikview publisher

Hi Rupali,

If you create a publisher task that is purely a distribute to folder (the red box in the attached), then the category is not passed to the end application and you need to instead manually set it once the task has run.

If you create the distribution as a mount to the QV server (the green box in the attached) then the category is passed to the end application

Hope that helps

Joe

Not applicable

Re: set category in qlikview publisher

Hi Ashfaq,

Thanks a lot for helping me in resolving the issue.

I was setting the category in Source documents section. But from your screen understood that we have to set it in user documents tab.

Done it and resolved the issue.

Thanks a lot once again....