Discussion Board for collaboration on QlikView Scripting.
Is it possible to do a BUFFER load on a preceding load and if so where does the BUFFER prefix go?
[some other field]
Go to Solution.
Well, perhaps you are asking this:
i.e. - you should place it at the top most of all preceding loads.
Does anybody have a clue on this?
Yes we can.
and path would be same, where you have stored your QVW.
Yes, it works with preceding load too. The way you showed should work fine. And if you are asking about location where it gets stored, check :
Use buffer only once at the top.
Yes, that's exactly the bit of information I need.