Qlik Community

QlikView Scripting

Discussion Board for collaboration on QlikView Scripting.

Announcements

Breathe easy -- you now have more time to plan your next steps with Qlik!
QlikView 11.2 Extended Support is now valid through December 31, 2020. Click here for more information.

Not applicable

Data Link Properties

I select OLE DB in the Edit Script box and then 'Connect' and am unable to connect to the data source or get a Failed to Connect to Qlikview Connector message.  Am I missing a driver, or is there anything else I can try.  I have tried it with or without the 'Force 32 Bit' checked.

Edit: I can't get the Data Link Properties box to appear.

3 Replies
gauravkhare
Contributor

Re: Data Link Properties

Hi There,

with what data source you are trying to connect??? You need a connector for connecting SAP Source rest most of the drivers are available in the drop down list....again if there is a problem in establishing connection then it might be the case that the password you are entering may be incorrect...

Not applicable

Re: Data Link Properties

I am attempting to connect to an ACCESS database. Using a Named CAL so I don't think that could be an issue. 

marsman82
New Contributor II

Re: Data Link Properties

Having the same problem. Did you find any solution yet?

QlikView is installed and published in a citrix environment.

I also get this error while trying to test an ODBC connection:

Connection Test Failed

Failed to connect to QlikView Connector.

Problem solved!

I Didn't have the required userrights to access the QlikView connector.

Message was edited by: marsman82: