Qlik Community

QlikView Scripting

Discussion Board for collaboration on QlikView Scripting.

Announcements

Breathe easy -- you now have more time to plan your next steps with Qlik!
QlikView 11.2 Extended Support is now valid through December 31, 2020. Click here for more information.

thnkgreen
Not applicable

Filter table box between two dates 'on the fly'

I realize that this may be a basic question, but I have forgotten if this is possible - can a user filter between two dates on a table box 'on the fly', meaning without having to type in set analysis or variables or anything like that.  Just right click on the column and enter a begina and end date?  Thanks.

1 Solution

Accepted Solutions
nirmalraj_kj
Not applicable

Re: Filter table box between two dates 'on the fly'

Hi thnkgreen

  check dropdown option for date then use like this >=20/01/2015<=24/01/2015.

Note: Dropdown option will available under presentation tab and makesure the seperators must same in date.

Hope this will helps you.

Thansk & regards

Nirmal

3 Replies
nirmalraj_kj
Not applicable

Re: Filter table box between two dates 'on the fly'

Hi thnkgreen

  check dropdown option for date then use like this >=20/01/2015<=24/01/2015.

Note: Dropdown option will available under presentation tab and makesure the seperators must same in date.

Hope this will helps you.

Thansk & regards

Nirmal

thnkgreen
Not applicable

Re: Filter table box between two dates 'on the fly'

Thank you.  I knew it could be done! 

MarcoARaymundo
Not applicable

Re: Filter table box between two dates 'on the fly'

Try this