Qlik Community

QlikView Scripting

Discussion Board for collaboration on QlikView Scripting.

Not applicable

Not able to select anything

Hi,

I have a qlikview dashboard with filters. Suddenly all the filters stopped working. I also have linked objects on my dashboard. I checked the "read only" property of the sheet is unchecked. What could be the reason of not being able to select the filters.

Thanks,

S

10 Replies
rajeshvaswani77
Valued Contributor III

Re: Not able to select anything

Hi Sheetal,

If they are gray then they are not related. Did you do limited load?

Or something to do with the Schema.

thanks,

Rajesh Vaswani

Not applicable

Re: Not able to select anything

No, limited load.

MVP
MVP

Re: Not able to select anything

Hi,

If possible attach that file, it would be easier to check and find the solution.

Regards,

jagan.

Siva_Sankar
Honored Contributor

Re: Not able to select anything

Press Ctrl +Alt+ S to access sheet properties. Go to security tab. Make sure you unchecked read only there.

Siva_Sankar
Honored Contributor

Re: Not able to select anything

check read only is unchecked as mentioned in the screenshot belowread only.png

Not applicable

Re: Not able to select anything

It is unchecked, still its not working.

Siva_Sankar
Honored Contributor

Re: Not able to select anything

after unchecking?. Did you check the apply to all sheets?

Is it happening to only one sheet or for all the sheet?

Is it happening for listbox only?

Also, try unchecking Admin Override Security under Security tab in Document properties.

qlikmsg4u
Valued Contributor

Re: Not able to select anything

Try to re-create the document by using following procedure,

Create a folder next to the document, with the same name only without ".qvw" and with added "-prj" - for example; for "Films.qvw", then name the folder "Films-prj". The next time you save the qvw document, the definition of the file with show up in xml files here. Changing the document and saving will update the xml references.

To re-create a document from the prj references, just create a blank document (Ctrl+N in QlikView), save it with the same name as the document, close it and re-open it in QlikView, and the document will be created after the definition.

Hope this helps!

https://community.qlik.com/thread/52642

vivek_niti
Contributor

Re: Not able to select anything

Hi,

Was there any field in Lock State before you reloaded the application? I have seen similar kind of issue that if we reload the application which has a locked field then after the reload it shows that no field is locked but actually it is. Try Unlocking all the fields and then do the selections.

Community Browser