Discussion Board for collaboration on QlikView Scripting.
Having trouble writing connector
The docs are saying
1. QlikView sends an execute request (QVX_EXECUTE) and waits for the Connector reply.
The request includes the SQL statement and the name of a data pipe, via which QVX
formatted result should be returned.
2. After executing SQL statement, the Connector sends the reply on the execute command
execution status, e.g. QVX_OK or QVX_TABLE_NOT_FOUND.
3. The Connector starts writing SQL statement result data to the data pipe.
4. QlikView, after receiving QVX_OK reply to the execute request, starts reading data from
the data pipe.
My connector recives QVX_EXECUTE
I send back QVX_OK via commad pipe and connector is immediately teminated before i try to open datapipe ans start writing the data
Tryed this option as well
Open data pipe < Not able to open it
Write data into data pipe
Does not work either
So what is the proper sequence of events?
Ignore this I have found what was the problem
Mike, am also facing issue. Can u help me solving this..