Qlik Community

QlikView Scripting

Discussion Board for collaboration on QlikView Scripting.

Announcements
QlikView Fans! We’d love to hear from you.
Share your QlikView feedback with the product team… Click here to participate in our 5-minute survey.
Rules, plus terms and conditions, can be found here.
Not applicable

SAP Connector and accessing BSEG

I have read several discussions on the problems with loading BSEG into a QVD but have not really seen any solutions.

I am fairly new to QV and scripting is not an area that I have spent much time on.

Some simple guidance would really be appreciated.

Thanks

4 Replies
disqr_rm
Valued Contributor III

SAP Connector and accessing BSEG

As long as you use SAP COnnector, you will have no problem loading BSEG and putting the data into a qvd file. Other than very large volume, you should have no problem.

Not applicable

SAP Connector and accessing BSEG

The load is using the SAP Connector and continually fails - probably due to the amount of data.

Not applicable

Re. :SAP Connector and accessing BSEG

did you check the memory buffer in SAP ? With the transaction ST02 in SAP you can do it.

with the program RSPFLDOC check the parameters rsdb/obj/buffersize. if the value is 4096,it 's not good.

A lot of problem, with the connector between SAP and Qlik, are on the memory buffer.

serge

suniljain
Honored Contributor

SAP Connector and accessing BSEG

To Extract BSEG Table you required sufficient buffer size on SAP R/3 Server. because it is cluster table i requires to pull data from multiple table and logically put it into single one. so it required buffer size up to 2 GB.

Community Browser