Skip to main content
Announcements
Have questions about Qlik Connect? Join us live on April 10th, at 11 AM ET: SIGN UP NOW
cancel
Showing results for 
Search instead for 
Did you mean: 
Not applicable

SAPQuery

Has anyone used the SAPQuery connection successfully?

I get to the point where it pops up a dialog box that should be listing queries, but it's empty.
We have over 3,000 queries in our SAP system (4.6c) so maybe it's timing out?

Do I need to do anything special to make the queries available to Qlikview?

Even a sample of the correct syntax for pulling data from a query would be helpful.

Thanks,Ben

1 Solution

Accepted Solutions
mike_garcia
Luminary Alumni
Luminary Alumni

I have not really used it, but this is stated in the Installation Guide:

1.1.1 User configuration

Use the same User as defined for the SQL Connector. You have to give this User access to the relevant SAP Query User Groups by using transaction SQ03. All Queries in the User Groups you assign will be available via the Query Connector.

Hope this Helps, Good Luck!

Mike.



Miguel García
Qlik Expert, Author and Trainer

View solution in original post

2 Replies
mike_garcia
Luminary Alumni
Luminary Alumni

I have not really used it, but this is stated in the Installation Guide:

1.1.1 User configuration

Use the same User as defined for the SQL Connector. You have to give this User access to the relevant SAP Query User Groups by using transaction SQ03. All Queries in the User Groups you assign will be available via the Query Connector.

Hope this Helps, Good Luck!

Mike.



Miguel García
Qlik Expert, Author and Trainer
Not applicable
Author

That worked! Thanks.